合勤642R端口映射配置二

弱电转贴员

Menu 11.1 - Remote Node Profile

Rem Node Name= ChangeMe Route= IP
Active= Yes Bridge= No

Encapsulation= PPPoE Edit PPP Options= No
Multiplexing= LLC-based Rem IP Addr= 0.0.0.0
Incoming: Edit IP/IPX/Bridge= No
Rem Login=
Rem Password= ********
Outgoing: Session Options:
My Login= czz7205800@adsl Edit Filter Sets= No
My Password= ******** PPPoE Idle Timeout(sec)= 0
Authen= CHAP/PAP PPPoE Service Name=
Schedule Sets=

Press ENTER to Confirm or ESC to Cancel:

注意在 Edit Filter Sets= No 空格键改为YES后，进入以下菜单：

Menu 11.5 - Remote Node Filter

Input Filter Sets：
protocol filters=6
device filters=
Output Filter Sets：
protocol filters=
device filters=
Call Filter Sets：
protocol filters=
device filters=

Enter here to CONFIRM or ESC to CANCEL:

将出现的 6 空格键去掉后回车存盘返回后 Edit Filter Sets= No 不要管它，回车存盘后设置15

进15之后

选2

进去之后再选1

Menu 15.2.1 - NAT Server Setup (Used for SUA Only)

Rule Start Port No. End Port No. IP Address
---------------------------------------------------
1. 21 21 192.168.1.10
2. 4661 4669 192.168.1.10

上面的
例子1是把21端口映射到192.168.1.10
例子2是把4661到4669的端口全部映射到192.168.1.10

Rule Start Port No. End Port No. IP Address
---------------------------------------------------
1. Default Default 192.168.1.10

这个是把所有端口全部都映射到192.168.1.10

我的例子：
Menu 15.2 - NAT Server Setup

Rule Start Port No. End Port No. IP Address
---------------------------------------------------
1. Default Default 0.0.0.0
2. 21 21 192.168.1.2
3. 80 80 192.168.1.2
4. 2300 2400 192.168.1.2
5. 47624 47624 192.168.1.2
6. 4661 4661 192.168.1.5
7. 4662 4662 192.168.1.5
8. 6881 6999 192.168.1.5
9. 0 0 0.0.0.0
10. 0 0 0.0.0.0
11. 0 0 0.0.0.0
12. 0 0 0.0.0.0

Press ENTER to Confirm or ESC to Cancel:

我的IP是192.168.1.5

关键字：端口映射